arduino stuffs
Diffstat (limited to 'libraries/Ethernet/examples/LinkStatus/LinkStatus.ino')
| -rw-r--r-- | libraries/Ethernet/examples/LinkStatus/LinkStatus.ino | 43 |
1 files changed, 0 insertions, 43 deletions
diff --git a/libraries/Ethernet/examples/LinkStatus/LinkStatus.ino b/libraries/Ethernet/examples/LinkStatus/LinkStatus.ino deleted file mode 100644 index af62ebb..0000000 --- a/libraries/Ethernet/examples/LinkStatus/LinkStatus.ino +++ /dev/null @@ -1,43 +0,0 @@ -/* - Link Status - This sketch prints the ethernet link status. When the - ethernet cable is connected the link status should go to "ON". - NOTE: Only WizNet W5200 and W5500 are capable of reporting - the link status. W5100 will report "Unknown". - Hardware: - - Ethernet shield or equivalent board/shield with WizNet 5200/5500 - Written by Cristian Maglie - This example is public domain. -*/ - -#include <SPI.h> -#include <Ethernet.h> - -void setup() { - // You can use Ethernet.init(pin) to configure the CS pin - //Ethernet.init(10); // Most Arduino shields - //Ethernet.init(5); // MKR ETH shield - //Ethernet.init(0); // Teensy 2.0 - //Ethernet.init(20); // Teensy++ 2.0 - //Ethernet.init(15); // ESP8266 with Adafruit Featherwing Ethernet - //Ethernet.init(33); // ESP32 with Adafruit Featherwing Ethernet - - Serial.begin(9600); -} - -void loop() { - auto link = Ethernet.linkStatus(); - Serial.print("Link status: "); - switch (link) { - case Unknown: - Serial.println("Unknown"); - break; - case LinkON: - Serial.println("ON"); - break; - case LinkOFF: - Serial.println("OFF"); - break; - } - delay(1000); -} |